Iwant to burn some photos of size around 600 mb to a cd i'm using KUBUNTU 12.04 and k3b for it but k3b gives following error

help
Devices
-----------------------
HL-DT-ST DVD+-RW GSA-T40N A100 (/dev/sr0, CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL) [DVD-ROM, DVD-R Sequential, DVD-R Dual Layer Sequential, DVD-RAM, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite] [%7]

K3b::IsoImager
-----------------------
mkisofs print size result: 271288 (555597824 bytes)

System
-----------------------
K3b Version: 2.0.2
KDE Version: 4.8.2 (4.8.2)
QT Version: 4.8.1
Kernel: 3.2.0-23-generic-pae

Used versions
-----------------------
mkisofs: 1.1.11
cdrecord: 1.1.11

cdrecord
-----------------------
scsidev: '/dev/sr0'
devname: '/dev/sr0'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.11
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 3 = CD-ROM XA mode 2
Driveropts: 'burnfree'
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVD+-RW GSA-T40N'
Revision : 'A100'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0012 (DVD-RAM)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x001A (DVD+RW)
Profile: 0x001B (DVD+R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x0010 (DVD-ROM)
Profile: 0x0009 (CD-R) (current)
Profile: 0x000A (CD-RW)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1053696 = 1029 KB
Drive DMA Speed: 12674 kB/s 72x CD 9x DVD
FIFO size : 12582912 = 12288 KB
Speed set to 4234 KB/s
Track 01: data 529 MB
Total size: 608 MB (60:17.20) = 271290 sectors
Lout start: 608 MB (60:19/15) = 271290 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type B, low Beta category (B-) (4)
ATIP start of lead in: -11834 (97:24/16)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 24
Manufacturer: SONY Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 88559
Starting to write CD/DVD at speed 24.0 in real TAO mode for multi session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Starting new track at sector: 0
Track 01: 0 of 529 MB written.
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 3C 30 00 80 02 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x02 Qual 0x00 (no seek complete) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 16.999s timeout 40s
/usr/bin/wodim: A write error occured.
/usr/bin/wodim: Please properly read the error message above.
write track data: error after 0 bytes
Writing time: 38.542s
Average write speed 94.0x.
Fixating...
Fixating time: 0.003s
/usr/bin/wodim: fifo had 192 puts and 1 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%.

cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=24 -tao driveropts=burnfree -multi -xa -tsize=271288s -

mkisofs
-----------------------
271288
I: -input-charset not specified, using utf-8 (detected in locale settings)
0.19% done, estimate finish Mon Jan 21 04:01:27 2013
0.37% done, estimate finish Mon Jan 21 00:24:43 2013
0.56% done, estimate finish Sun Jan 20 23:09:57 2013
0.74% done, estimate finish Sun Jan 20 22:33:50 2013
0.92% done, estimate finish Sun Jan 20 22:12:01 2013
1.11% done, estimate finish Sun Jan 20 21:57:25 2013
1.29% done, estimate finish Sun Jan 20 21:46:53 2013
1.48% done, estimate finish Sun Jan 20 21:39:57 2013
1.66% done, estimate finish Sun Jan 20 21:33:45 2013
1.84% done, estimate finish Sun Jan 20 21:28:47 2013
2.03% done, estimate finish Sun Jan 20 21:24:42 2013
2.22% done, estimate finish Sun Jan 20 21:21:12 2013

mkisofs calculate size command:
-----------------------
/usr/bin/genisoimage -gui -graft-points -print-size -quiet -volid Abhi Bhagyashree -volset -appid K3B -publisher MAHESH M KADAM -preparer MAHESH M KADAM -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-mahesh/k3bsC2391.tmp -rational-rock -hide-list /tmp/kde-mahesh/k3bqN2391.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-mahesh/k3bGk2391.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-mahesh/k3bnv2391.tmp

mkisofs command:
-----------------------
/usr/bin/genisoimage -gui -graft-points -volid Abhi Bhagyashree -volset -appid K3B -publisher MAHESH M KADAM -preparer MAHESH M KADAM -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-mahesh/k3bfE2391.tmp -rational-rock -hide-list /tmp/kde-mahesh/k3bwA2391.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-mahesh/k3bjt2391.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-mahesh/k3bOm2391.tmp

Posted 1 year ago
Top